Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 9 replies
  • Subscribers 6 subscribers
  • Views 22987 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Detect new interface/nic without reboot

infoland
Hi,

We run Sophos UTM on a vSphere VM, if we add a new NIC/interface in vSphere you have to reboot the UTM to see the new interface. Is there a way of detecting it with a Linux command, so i don't have to reboot?

Thanks,

Freek


This thread was automatically locked due to age.
Parents
  • 0

    Just ran through this adding flexiport modules to our SG430's in a HA setup. You HAVE to reboot. 

    The config is saved to the master. So you will need to shut down both. Add the module/interface to the master, boot up the master then boot up the slave.

    Invoking the linux command or doing them one at a time will only show up in the tech support section but not in the interface config.

    We did ours with about 5 mins of downtime.. and they are in separate buildings.

  • 0 in reply to tobrien

    Thanks for your reply!

    I will try that

Reply Children
No Data
Unfiltered HTML