This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Astaro with ATT U-Verse

I am in the process of switching from DSL to U-Verse. I also requested a block of static IP addresses. Now, I understand that the modem used for U-Verse does not support bridged mode allowing me to do PPOE in Astaro.

What are my alternatives? Did somebody get this to work?

ATT is also talking about an RG (residential gateway). It sounds like that it is a modem/router combination device. Are there alternatives? Is there a 3rd party modem?

Technician will come to my home on Saturday. So, I would appreciate some quick feedback.

Thanks,
Jens

This thread was automatically locked due to age.

Parents

0 BarryG over 13 years ago

Hi, you should be able to add all 5 addresses to Astaro's EXT interface (as 'additional' addresses); then you can use them for DNATs and/or SNATs.

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BarryG over 13 years ago

Hi, you should be able to add all 5 addresses to Astaro's EXT interface (as 'additional' addresses); then you can use them for DNATs and/or SNATs.

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 jstraten over 13 years ago in reply to BarryG

Thanks Barry!

I wasn't sure that's possible since I have to use DHCP to assign an IP to Astaro.

Looks like I should be good to go now. [:)]

Thank you again to everyone taking the time to reply.

The connection change is rescheduled to end of month, but I will report back and share my results.

Best regards,
Jens
Cancel
Vote Up 0 Vote Down

Cancel