This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Dell R240 - Install

Has anyone install UTM Software on a Dell R240?

Can't seem to get past 3.6sec of boot during pci setup.

Using asg-9.705-3 iso.

I'm an old school server guy and this thing has got all this enterprise management who-ha and graphic bios setup. Lifecycle Controller... really!? (but I digress)

I can boot proxmox install iso, Ubuntu 20.04 install iso, but UTM iso hangs while setuping up the pci. Same result when I try to install from usb stick or burned DVD.

Not sure where to start.

This thread was automatically locked due to age.

Top Replies

Pedulla over 3 years ago +1 verified

Solution!!!! This is a bios setting in the Processor section. x2APIC Mode needs to be disabled. Thanks Amodin for the direction. Hope this is useful for someone else down the road.

Parents

+1 Pedulla over 3 years ago

Solution!!!!

This is a bios setting in the Processor section.

x2APIC Mode needs to be disabled.

Thanks Amodin for the direction. Hope this is useful for someone else down the road.
Cancel
Vote Up +1 Vote Down

Cancel
0 Pedulla over 3 years ago in reply to Pedulla

Interesting bit of info. After the install, I turned it back on and it boots fine.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Pedulla over 3 years ago in reply to Pedulla

Interesting bit of info. After the install, I turned it back on and it boots fine.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data