Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 5 subscribers
  • Views 2258 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Intel x520-da2 - only one port

fake user

Hello,

 

I recently switched a couple of Intel i210s for x520-da2s. To do this I did the following:

  1. powered down
  2. removed old nics
  3. inserted new nics
  4. turned back on

Upon booting, both the new nics were recognized and available, but only one port on each. How do I enable both ports on each nic?

 

Many thanks in advance.



This thread was automatically locked due to age.
Parents
  • 0

    Hi,

    UTM OS is not plug-n-play.  Apparently, the i210 driver will work for the first port, but not the other.  Your only solution is to re-image from ISO so that the x520-DA2s are recognized and their driver loaded.  You can confirm that these NICs are supported by consulting the UTM HCL.

    I'll move this thread to the Hardware forum.  If your NICs aren't in the official HCL, check the Unofficial HCL at the top of the Hardware forum.

    Cheers - Bob

     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
  • 0 in reply to BAlfson

    Thanks as always BA. I will try a fresh install and see what happens.

  • 0 in reply to fake user

    Reinstall sadly had no effect. Each card shows only port available.

    Interestingly they're being reported as X520-2 not X520-DA2 

    Does someone more knowledgeable than me know the nuances between these two models? Have I been mis-sold? 

Reply Children
No Data
Unfiltered HTML