Using a SG310 for Home Firewall

Question

Our company after using the SG 310 for several years (see my prior posts), is moving entirely to Meraki (much to my chagrin). Anyway, it isn't a total loss as I get to take the now-retired SG 310 home. I fancied I would get a UTM Home license, but when I go to activate it I get an error: "Cannot use ASG software license on SG310 device" 
 Looking through the forums for similar messages, I am not clear on what I need to do. Do I need to re-flash the 310 to a different OS? Is there even a license available for me to use for this? I can easily swap out the hard drives (I have a couple of unused 500GB drives available) and put a new OS on it if need be. Are there any good guides that are available out there?

BAlfson · Accepted Answer

I would sell the SG on eBay, buy a new, small, energy-efficient device and keep the change. 
 Check the last page or two of the unofficial HCL at the top of the Installation forum. Note that Realtek, Marvel and 3Com NICs are to be avoided. 
 I see you live in the USA where, unlike in Europe, electricity is cheap. If you decide to keep the 310, consult Use Appliance with a home license . 
 Cheers - Bob

DKKDG · Answer

DrIndyJones, 
 if the UTM Hardware version is installed you just need to ssh to your device and remove/rename the etc/asg file. Then reboot the the device and install your home license. 
 But due to energy consumption I do not recommend the SG310 for home use. 
 Best Regards DKKDG