Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 11 replies
  • Subscribers 5 subscribers
  • Views 19987 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Show running configuration from shell?

GordonSS
I'm looking to see the full running configuration when logged in using SSH - something like an equivelant to Cisco's 'show running-config' or Juniper's 'show config'.

Can this be done with the UTM?


This thread was automatically locked due to age.
Parents
  • 0
    I'm looking to see the full running configuration when logged in using SSH - something like an equivelant to Cisco's 'show running-config' or Juniper's 'show config'.

    Can this be done with the UTM?

    No. 

    There are some shell commands (See here) but there is no full-featured CLI built-in.

    This would be by the way a feature, I would expect from Copernicus, but so far, I couldn't find it on their Roadmap or Featurelist.

    Please send me Spam gueselkuebel@sg-utm.also-solutions.ch

Reply
  • 0
    I'm looking to see the full running configuration when logged in using SSH - something like an equivelant to Cisco's 'show running-config' or Juniper's 'show config'.

    Can this be done with the UTM?

    No. 

    There are some shell commands (See here) but there is no full-featured CLI built-in.

    This would be by the way a feature, I would expect from Copernicus, but so far, I couldn't find it on their Roadmap or Featurelist.

    Please send me Spam gueselkuebel@sg-utm.also-solutions.ch

Children
Unfiltered HTML