This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SD-RED 60 Traffic throughput

Hi there,

I have just set up a SD -RED 60 in Standard / unified operation mode and this appears to have connected and when I attached a laptop to the device I obtain an IP address from the configured DHCP on the firewall.

When I look at the 'Red to LAN' firewall rule it shows in 0 B, out 0 B which seems strange as during testing I was able to connect to internal servers from Laptop.

What is the best way of monitoring the traffic that is going through the RED 60 in real time?

Thanks

Laurie



This thread was automatically locked due to age.
Parents
  • Hello Laurie,

    can you check, if you actually turned on logging for that particular rule?

    There is a checkbox in the rule definition for that.

    Mit freundlichem Gruß, best regards from Germany,

    Philipp Rusch

    New Vision GmbH, Germany
    Sophos Silver-Partner

    If a post solves your question please use the 'Verify Answer' button.

Reply
  • Hello Laurie,

    can you check, if you actually turned on logging for that particular rule?

    There is a checkbox in the rule definition for that.

    Mit freundlichem Gruß, best regards from Germany,

    Philipp Rusch

    New Vision GmbH, Germany
    Sophos Silver-Partner

    If a post solves your question please use the 'Verify Answer' button.

Children