Help us enhance your Sophos Community experience. Share your thoughts in our Sophos Community survey.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Temporarily set ip on UTM not working (gets overwritten)

Hi there,

for some debugging reasons I´d like to tempoarily set a manual ip on a UTM Interface. At least the command is working, I can use ifconfig eth0 192.168.0.1 netmask 255.255.255.0 Broadcast 192.168.0.255 or ip addr add 192.168.0.1/255.255.255.0 dev eth0, but after a few seconds the address is being removed...

I think there is the config daemon or sth. else, that is overwriting that manual config all the time.

Is there a way to stop that and temporarily set the interface address?

This system is not productive.

Thanks.



This thread was automatically locked due to age.
Parents Reply Children