2nd WAN - no failover or load balancing

Question

Hello. Looking for some config help for the future state to sort this out please for UTM 9. Thanks. 
 Current State: 
 
 LAN = 192.168.0.x/24 -> WAN - ISP 1 
 
 All working fine for outbound Internet. 
 Future State: 
 
 LAN = 192.168.0.x/24 -> WAN - ISP 1 
 DEVICE1 = 192.168.0.130 -> WAN2 - ISP 2 
 
 Simply want DEVICE1 to use WAN2 as its gateway while the rest of the network uses WAN1. 
 I am not looking for failover or load balancing at this point. 
 Thanks.

Raphael Alganes · Accepted Answer

We can use, Itf. Persistence: Interface persistence is a technique which ensures that subsequent connections from a client are always routed over the same uplink interface. 
 Then we under it we can use: By Interface: Select an interface from the Bind Interface drop-down list. All traffic applying to the rule will be routed over this interface. 
 and this would achieve the use case above for your future state. 
 Future State: 
 
 LAN = 192.168.0.x/24 -> WAN - ISP 1 
 DEVICE1 = 192.168.0.130 -> WAN2 - ISP 2

Regards,

Raphael Alganes · Answer

Hi, 
 
 Thanks for reaching out to Sophos Community and hope you are well. 
 Seems UTM Multipath rules configuration would achieve your use case: https://support.sophos.com/support/s/article/KB-000034635?language=en_US 
 
 Hope this helps and thank you for choosing Sophos 
 
 Regards,

PhilippRusch · Answer

Hello, 
 please show us your screenshots from the "uplink balancing" tab and the edits of your "multipath rules". 
 In contrast to their name "multipath rules" can be used to force the use of only one interface for special clients or services. 
 Let us help you getting this solved.

2nd WAN - no failover or load balancing

Top Replies