This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

500 MBPS point to point

We have a 500 MBPS point to point that runs from our main office to our backup site. We have been struggling for a while now trying to figure out why we can only get 60 MBPS out of it. We have had Spectrum test the line several time and everytime they show it is running 500 MBPS.

We have forced the duplex on the firewall and nothing.

We have tested with 2 laptops and we get the same results using iperf.

We are looking for some ideas on where to go next.

Thanks!

Dave

This thread was automatically locked due to age.

Parents

0 BAlfson over 2 years ago

Hey Dave,

What speeds do you get if you connect two laptops directly, leaving the UTMs out of the picture?

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 David Haven over 2 years ago in reply to BAlfson

Same speeds. working with Spectrum they are pointing towards out tcp window size.
Cancel
Vote Up 0 Vote Down

Cancel
0 David Haven over 2 years ago in reply to David Haven

It has to be on the Spectrum side. If we connect directly to the spectrum equipment the problem still exists.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 David Haven over 2 years ago in reply to David Haven

It has to be on the Spectrum side. If we connect directly to the spectrum equipment the problem still exists.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data