General Discussion Reaction to 100% SWAP usage

UTM Firewall requires membership for participation - click to join

Thread Info

State Verified Answer
Locked Locked
Replies 3 replies
Subscribers 6 subscribers
Views 2175 views
Users 0 members are here

Options

Suggested

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Reaction to 100% SWAP usage

LHerzog over 2 years ago

Hi,

any suggestion how to react to this high SWAP usage on a SG135?

Firmware 9.707-5

Should I ignore it or flush something? It's HA.

This thread was automatically locked due to age.

Top Replies

PhilippRusch over 2 years ago +1

Hi, I would just do a manual failover to Node2 and then see whtat happens after some 10 minutes or so.

0 PhilippRusch over 2 years ago

Hi,

I would just do a manual failover to Node2 and then see whtat happens after some 10 minutes or so.

Mit freundlichem Gruß, best regards from Germany,

Philipp Rusch

New Vision GmbH, Germany
Sophos Silver-Partner

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up +1 Vote Down

Cancel
0 LHerzog over 2 years ago in reply to PhilippRusch

thanks four your answer PhilippRusch

I could find out it's caused mostly by snmp agent gone wild consuming 3,8GB RAM and swapping with 3,4 GB.

I restarted only snmpd and all was fine afterwards
Cancel
Vote Up 0 Vote Down

Cancel
+1 LHerzog over 2 years ago in reply to LHerzog

CLI

top

f -> p to add Swap to top

O -> p to sort by Swap state
Cancel
Vote Up +1 Vote Down

Cancel