This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How do I configure in Tap or discovery mode

Hi All,

I thought I had done this before some years back, where I could configure the UTM with only one interface (with the switch port mirroring the firewall traffic) and configure it to just discover the network traffic and after about 3-4 weeks it would be able to proivde a report on what traffic was flowing to/from the firewall. I know I can do this by putting it in Bridge mode, but I did not want to disrupt the current network in any way.

can anyone help with this?

thanks



This thread was automatically locked due to age.
  • I can't "see" the topology you describe - maybe a stick figure diagram?

    Cheers - Bob

     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA