Hello,
I need some advice regarding my dmz rules, and conf. I have just manually created fw rules. I have a VPN Router connecting to VPN Tunnel 443 in the DMZ eth2 , where all internal lan clients and VPN SSL Clients should access the internet over the proxy (Standard and Transparent).
Multipath Rule set:
Internal (Network) → Any → Internet IPv4 → DMZ VPN
The VPN Router IP is set as default Gateway on eth2 under Interfaces. When i try to remove the IP under Interfaces and press Save i get the message:
Interfaces & Routing → Interfaces → Uplink Balancing:
At least one active interface is needed. Uplink Balancing will be disabled.
When i disable Uplink Balancing, all my Multipath Rules get set to undefined
What do i have to change, to get the Router working without DMZ Default GW?
Thx
Sally
This thread was automatically locked due to age.
