Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 5 subscribers
  • Views 875 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Change Interface type from Ethernet to DSL (PPPOE)

IT TeamWDC

Hi

I would like to change my current internet facing Interface from type Ethernet to DSL (PPPOE).

If I update the current interface will this have an impact on rules and other configuration? Is a new interface a better idea?

The interface has these:

Used in these configurations:
  Interfaces & Routing → Interfaces → Multipath Rules
  Interfaces & Routing → Interfaces → Uplink Balancing
  Interfaces & Routing → Interfaces → Uplink Balancing
  Network Protection → NAT → Masquerading
  Interfaces & Routing → Interfaces → Uplink Balancing
  Web Protection → FTP → Advanced
  Interfaces & Routing → Interfaces
  Network Protection → Firewall → Rules
  Interfaces & Routing → Quality of Service (QoS) → Status
  Interfaces & Routing → Interfaces → Uplink Balancing

Thanks



This thread was automatically locked due to age.
Parents
  • FormerMember
    0 FormerMember

    Hi  

    Thank you for reaching out to the Community! 

    If the object is used in other configurations, it might not allow you to make the change. I would advise you to configure a new interface and then update the other configurations accordingly.

    Thanks, 

Reply
  • FormerMember
    0 FormerMember

    Hi  

    Thank you for reaching out to the Community! 

    If the object is used in other configurations, it might not allow you to make the change. I would advise you to configure a new interface and then update the other configurations accordingly.

    Thanks, 

Children
No Data
Unfiltered HTML