Shutdown one unit in HA setup

Question

Hi! 
 I want to physically move my UTM boxes (SG310). They run in a HA setup. 
 My question is - how do I do this with the least amount of downtime? 
 I'm guessing that I should 
 1. shutdown (power off) the SLAVE unit ( how? ) 2. physically move SLAVE unit 3. reconnect all cables to SLAVE unit and power it back on 4. wait for sync 5. make SLAVE unit MASTER ( how? ) 6. repeat steps 1-3 for new SLAVE unit Is this the right approach? 
 Also note my questions regarding shutdown of a single node (SLAVE unit) and switching MASTER role between units. (steps 1 and 5) 
 Kind regards 
 Karsten Stolten

dirkkotte · Accepted Answer

Your stepa are ok. 
 Within webadmin goto "management / high availability". 
 here you see booth nodes. 
 click shutdown to slave first. 
 after slave is online again (no longer syncing = state "ready") you can shutdown the master from here too. 
 The slave becomes your new master. 
 Or use the frontpannel as explained already.

DKKDG · Answer

Hi Karsten, 
 your steps are correct so far. 
 For step one just go to the appliance and use the front panel to shutdown the device. This also applies to step 5. 
 Here you just power off the MASTER device after the sync is successful. 
 Best Regards DKKDG

KarstenStolten · Answer

Thank you dirkkotte - for the detailed steps. Exactly what I needed! ;o) 
 
 Kind regards 
 K. Stolten