This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SSL VPN through IP Sec Tunnel

Dear Community,

we have two Sophos UTMs in two offices (UTM A, Office 1 and UTM B, Office 2), which are connected via an IPSec VPN tunnel. Local users on UTM A can access the network on UTM B.

External users connect via SSL VPN to UTM A and can not access the network on UTM B, they can just reach UTM A. Do you have an idea what we need to configure, so that users that connect to UTM A via SSL VPN can also access the network on UTM B trough the IPSec tunnel?

Many thanks in advance and best regards, Kai

This thread was automatically locked due to age.

0 dirkkotte over 5 years ago

do you allo the SSL-VPN-Ip Pool (10.242.2.0/24 by default) within the IPSec definition and network on UTM B within SSL-VPN definition too?

Dirk

Systema Gesellschaft für angewandte Datentechnik mbH // Sophos Platinum Partner
Sophos Solution Partner since 2003
If a post solves your question, click the 'Verify Answer' link at this post.
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 5 years ago

Hallo Kai and welcome to the UTM Community!

I think you might be looking for How to allow remote access users to reach another site via a Site-to-Site Tunnel.

Note that if both ends of the site-to-site tunnel are UTMs, you must ensure that one side has "VPN Pool (SSL)" not = 10.242.2.0/24.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel