This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

site-to-site VPN

You have been asked to create a site-to-site VPN connection with another company that will be involved in a large project with yours.

Knowing that they do not have a UTM, what is the best option for a site-to-site VPN protocol between two different devices?

PPTP
L2TP
SSL
IPsec



This thread was automatically locked due to age.
  • Hi,

    the most common way IPSec which is supported by the most devices.

    But you'll have to check out the supported Tunneltypes of the other device.

  • Ciao Stefano, Hallo Ralf - welcome to the UTM Community!

    Agreed with Ralf that IPsec is almost universally available.  Configuring an SSL VPN site-to-site with something other than two UTMs is very difficult and I know of no good set of instructions to make it work.

    The UTM cannot be a client for L2TP/IPsec or PPTP as those are only available in Remote Access.  Some consumer routers are able to act as a client and might be able to connect to the UTM, but it would require a static route to allow people behind the UTM to connect through the tunnel to devices in the other network.

    Which Sophos appliance will you be using on your side?

    Cheers - Bob

     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA