Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 4 replies
  • Answers 1 answer
  • Subscribers 6 subscribers
  • Views 14718 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

User authentication failed - User Portal

Milos Tomanicek

Hi guys,

I have here SG330 device. Users are synced from AD backend.

Now since user accounts in active directory are able to log on to only specific workstations (AD user account attrribute "logonworkstation" has been set), these users are not able to authenticate if they try to log in to UTM through User portal. Only message "Invalid username/password etc" shows up.

This behavior is caused exactly by setting the "logonworkstation" attribute (we are not facing here any other problem). If I remove the attribute, users are able to log in just fine.

So the question is:

What computer name for the UTM device shloud be set as value for "logonworkstation" attribute in AD(we already tried the name of the UTM computer object in AD but no luck)? Or is it even possible to make the setup as we desire?

 

Thank you

Best regards

Memo



This thread was automatically locked due to age.
Parents
  • 0

    Hi,

    The same problem in Sophos XG firewall with the same configuration, users accounts in active directory are able to log on to only specific workstations

    The solution: We have had to add the domain controller as the allowed machine to log in to each user.

    It would be nice that Sophos to answer if this is normal

Reply
  • 0

    Hi,

    The same problem in Sophos XG firewall with the same configuration, users accounts in active directory are able to log on to only specific workstations

    The solution: We have had to add the domain controller as the allowed machine to log in to each user.

    It would be nice that Sophos to answer if this is normal

Children
No Data
Unfiltered HTML