This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Sophos UTM - New interface from att fiber ethernet business wont connect

Todd Poynton over 6 years ago

Hello,

I configured a new interface for our secondary att business fiber ethernet at our office.

External WAN - ATT

[Down]

on eth5

[12.244.109.114/30]

MTU 1500 · DEFAULT GW 12.244.109.113

Set it up to be on standby mode, and when I turn it active, it does not connect. Shows down. When i connect directly to their equipment from my lpatop and use the same info above, it connects and I have internet. Any ideas what I am missing?

Thanks,

Todd

This thread was automatically locked due to age.

Parents

0 Ol Deda over 6 years ago

Click on Aditional Adresses, than click back Interfaces
Cancel
Vote Up 0 Vote Down

Cancel
0 Todd Poynton over 6 years ago in reply to Ol Deda

So I have to add this new back up wan to the main interfaces page as well as the additional address's page?
Cancel
Vote Up 0 Vote Down

Cancel
0 Ol Deda over 6 years ago in reply to Todd Poynton

I mean it shows Down for a few seconds. When you reload the page, it shows up

If not, try to not let the link automatic (under hardware)
Cancel
Vote Up 0 Vote Down

Cancel
0 Todd Poynton over 6 years ago in reply to Ol Deda

Hello, it never shows up, just down. disabled link automatic in hardware for that e5 nic and still nothing.
Cancel
Vote Up 0 Vote Down

Cancel
0 Ol Deda over 6 years ago in reply to Todd Poynton

Have you tried another lan cable or maybe crossover. It seems very strange
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Ol Deda over 6 years ago in reply to Todd Poynton

Have you tried another lan cable or maybe crossover. It seems very strange
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data