Thread Info
  • State Verified Answer
  • Locked Locked
  • Replies 1 reply
  • Subscribers 10 subscribers
  • Views 2894 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

APX320 on XG - Routing issue

webmaster webmaster

Hi,

This is probably a more of a routing than a wireless issue, but I'll give it a try.

I have a XG 230 with a number of available HW ports and a brand new APX320.

I have a subnet to the outside where the office traffic flows trough x.x.x184 and I would like the wifi (Guest) traffic to go trough x.x.x.191

Should the user need anything on our LAN they will have to go trough VPN.

I have connected APX320 to port 6 on the XG and enabled the port. Set it to Wifi zone with address: 192.168.108.1/255.255.255.0 (In my simple mind that would be the gateway)

I gave the network interface this address.: 192.168.108.200/255.255.255.0. (Why not the GW address??)

I have setup a DHCP for the WIFI zone. I have defined the wifi network to 192.168.108.0/24. Client separation and so on.

I have setup a routing from the wifi network to the WAN.

APX is online, I can connect to it with a laptop.(Did only come online after a FW update, but that could be the restart)

I can ping the APX from the laptop, but not the network interface at .200 nor .1.

So I'm stuck. Ideas anyone?

Gary



This thread was automatically locked due to age.
Unfiltered HTML