Hello, after week new PoE+ switch arrived, so i connected two APX740, AP55C and on APX im getting client link speed only 400Mbps and with AP55C 866Mbps without problem, any suggestions why APX does not serve full speed? Client is Wave2 capable and same link speeds are also on Samsung S10+ phone.
APs are managed by UTM 9.7...
Vitek
You know that MHz and GHz are not the same. If you use 5GHz you can use 20,40, 80MHz and more..
The problem wasn't the 5GHz band. The problem was probably because there was too much noise in your air environment. And your wireless card wasn't able to manage this 80MHz bandwidth because the channels you were using were too crowded.
When you select 80MHz you are using lot of channels to have this size of bandwidth. is not always the best option, probably... the worst in most cases.
You can't setup a 80MHz bandwidth if you are not alone in the wifi space.
My suggestion: 5GHz band with 20MHz bandwidth. Or you can try 40MHz if the air is clean of noisy neighbours..
In the spec sheet says it is capable.
I have never setup above 80MHz, but some team mates told me you need to do it a the advanced console. BUT, if you do it you lose support.
The best option would be open a case with sophos support.
