Thread Info
  • State Suggested Answer
  • Replies 6 replies
  • Answers 2 answers
  • Subscribers 5 subscribers
  • Views 5053 views
  • Users 0 members are here
Options
Suggested

BUG - HA does not configure

Wesley Heydlauff1

I have installed EAP3 Refresh 1 and HA does not work, i have port 1 for lan, port 2 WAN port 3 is my DMZ/Wireless and port 6 is setup for HA

on primary selected port 6 and set as quick and clicked initiate. it is in discovery mode

on the secondary went into HA set same key, and told the second unit to use port 6 for HA, wired directly to the primary unit, and it spins and then comes back and does nothing. will never configure the secondary unit. it acts like it will not work unless on port 6

 

This is Critical to get this to function. also if you try to select interactive it shows no ports that can be selected for HA.

Parents Reply
  • 0 in reply to Rana Sharma

    registration looks like it worked. You should add a note in the HA Setup document to make sure to register. the only problem with registering requirement is that it does not allow a quick HA mode function as you have to get the device on the internet first.

    Also if you have an automatic HA setup like the SG firmware had where you just plugged it in how would that work? also how would it work it one unit dies and you have to swap the hardware?

     

    Also the document does not says that you setup your ports and everything else after HA is setup.

Children
No Data
Unfiltered HTML