Create linked NAT rule not working

Hi,

you set the translation in the service type. You change the first line to MASQ.

To remove a linked rule you delete it. by clicking on the blue circle to the right of the rule.

Ian

Hi Ian,

I already tried that before, but still the same, all other options are disabled.

Also, I'm doing a DNAT, so the translated source should be original.

For the Linked NAT rule, you mean to delete it under the NAT rules tab? It cannot be unlinked or deleted from the Firewall rules?

cannot click the linked NAT rule

Hi Ian,

I already tried that before, but still the same, all other options are disabled.

Also, I'm doing a DNAT, so the translated source should be original.

For the Linked NAT rule, you mean to delete it under the NAT rules tab? It cannot be unlinked or deleted from the Firewall rules?

cannot click the linked NAT rule

Hi,

that to me looks like an internal network and you do not need a NAT rule.

You cannot unlink a NAT rule from the firewall rule, you can only delete it from the NAT rule table.

The only option that you can change in a linked NAT rule from the NAT is MASQ setting all other changes are managed from the firewall rule.

Ian

Here I create a firewall rule for RDP to Server1.

If I click the Create linked NAT rule, I cannot do anything.

So I created a NAT rule from the NAT rules tab.

Why I cannot do anything from the Firewall rules > Create linked NAT rule?

Also, if I change the Outbound interface from Any to LAN, the DNAT doesn't work.

Hi Mark,

there are two ways of achieving what you want.

1/. firewall rule source WAN -> ANY -> service YRDP (1:65535 - 3389) destination LAN -> your server IP -> log -> allow

create linked NAT rule set MASQ.

2/. is using a server template firewall rule which I am not very confident in setting up that will then allow you to do your DNAT.

Ian