EAP 3: Quick HA problems

Hi all,

Have two SG 210 rev. 3 devices.

Waited for EAP3 to test the new HA version (QuickHA)

My primary device has been upgraded from v17 to v18 EAP1 --> EAP 2 and now, successfully EAP 3

My secondary device was installed with EAP 3 ISO.

 

Did setup both, with Quick HA, everything went fine and "green", did a failover to secondary device, all went well and primary rebooted.

 

But..never came back up.

 

Looking in CTsyndc.log on seconday device, all sync are successfull, except for dhcp6.lease file, as I do not use IPv6 dhvcp server.

 

Also LCD in old primary is just blank with a "-" sign in the top line.

 

Attached a screen, and it went into XG Failsafe.

 

The new master (The secondary), have Dead heartbeat service, also UI i VERY slow, CPU is just 6%.

 

I am now formatting both SG210 with EAP 3 ISO, restore from backup (without HA), and will try the Quick HA setup again.

i will keep you posted :-)

Parents Reply Children
No Data