Hi all,
Have two SG 210 rev. 3 devices.
Waited for EAP3 to test the new HA version (QuickHA)
My primary device has been upgraded from v17 to v18 EAP1 --> EAP 2 and now, successfully EAP 3
My secondary device was installed with EAP 3 ISO.
Did setup both, with Quick HA, everything went fine and "green", did a failover to secondary device, all went well and primary rebooted.
But..never came back up.
Looking in CTsyndc.log on seconday device, all sync are successfull, except for dhcp6.lease file, as I do not use IPv6 dhvcp server.
Also LCD in old primary is just blank with a "-" sign in the top line.
Attached a screen, and it went into XG Failsafe.
The new master (The secondary), have Dead heartbeat service, also UI i VERY slow, CPU is just 6%.
I am now formatting both SG210 with EAP 3 ISO, restore from backup (without HA), and will try the Quick HA setup again.
i will keep you posted :-)
