[NC-52441] Unable to update to EAP1 refresh 1

After rebooting the appliance , it tries to boot the new eap1 refresh firmware and this is the result

What is your current situation? 

Can the appliance boot or not? 

And which slot has which installation + which is currently running? 

As reported, the XG seems to unable to install the new fresh release. I decided to upload and XG does not boot anymore (I took a picture with the mobile).

The only way to boot was to move the Xg to my tv, connect a vga cable, keyboard, check what happened and reboot by using GRUB  and select the previous version v18. Everything worked. Then I powered off the machine, powerd on again and took time from the boot to the grub menu with a stopwatch (all my tv are wall-mounted).

Moved XG and the keyboard to the other room and after 10 secs I used the upper key to select the previous Firmware version and pressed ENTER.

[:D]

To investigate, some dev can contact me and I will give them access to XG.

Regards

As reported, the XG seems to unable to install the new fresh release. I decided to upload and XG does not boot anymore (I took a picture with the mobile).

The only way to boot was to move the Xg to my tv, connect a vga cable, keyboard, check what happened and reboot by using GRUB  and select the previous version v18. Everything worked. Then I powered off the machine, powerd on again and took time from the boot to the grub menu with a stopwatch (all my tv are wall-mounted).

Moved XG and the keyboard to the other room and after 10 secs I used the upper key to select the previous Firmware version and pressed ENTER.

[:D]

To investigate, some dev can contact me and I will give them access to XG.

Regards

Hi lferrara,

          Thanks for your feedback, I will send you PM for more details purpose.