REPORT - testing of IPv6 in EAP1

Hi Ian,

It seems that I still have issues with IPv6:

• The XG seems to be sending the proper IPv6 addresses to the local network via DHCP.  
• I can access the XG with its IPv6 address.  
• The XG seems to connect properly with the ISP via IPv6 and gets the proper info.  Connection is shown as "green".
• I still cannot connect to the internet via IPv6.
• The IPv6 NAT rules show that they've been recently used.

One seemingly odd thing that I've noticed is that the connected devices show the connected gateway as the IPv4 of the XG that I set but they show the IPv6 address as a link-local address.  I would think that this should show as the IPv6 address that I set on the XG.  Could it be that they are not using the correct IPv6 gateway?

This is with EAP1.

My IPv6 setup working fine under XG 17.

Best regards,

Hi Casual_User,

        Thanks for your feedback, I will send you PM for more details purpose.

My ISP assigned a link-local address for the gateway and I have a real IPv6 address assigned to the WAN interface.

More testing today after the upgrade restart yesterday.

Ian

Found why my testing failed yesterday, I enabled know users and there are no known IPv6 users on my XG at the moment, all are assigned by dynamic addressing.

Ian