Important note about SSL VPN compatibility for 20.0 MR1 with EoL SFOS versions and UTM9 OS. Learn more in the release notes.

Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 15 replies
  • Answers 2 answers
  • Subscribers 41 subscribers
  • Views 27003 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Adding AP-100 to XG firewall

adhodgson

Hi,

I have an AP-100 unit which I want to add to the XG firewall after doing the initial setup.  I had to reset to factory defaults as I didn't complete one of the options in the setup wizard, and subsequently had no outbound rules on the firewall.

Anyway, I can see the AP registering in DHCP, and the wireless log has a lot of entries in it regarding not allowing the AP to connect until it is approved.  I can see the AP in the wireless AP groups, but can't select it there.

When I go to the Access Points option to approve it, the table of unapproved devices just had a piece of text underneath the table headings suggesting that entries are loading, but nothing ever happens.

Anyone seen this before?  Looks like I can't go back to UTM at this stage because the firmware of the AP has updated, so I want to try and get this sorted on XG if I can.

Thanks,

Andrew.



This thread was automatically locked due to age.
Parents Reply Children
No Data
Unfiltered HTML