In my early days we put the default + vlans on all port 1 (1 gigabit), since we having some issue with smb traffic and sometimes freezes/spikes, i wanted to try to change that.
So i thought i could use port 4-8 and trunk them together and allow those same vlan ids on that and connect them over Lag-LACP to our HP Switch.
What are the needed steps to do that? Or do i need do evrything all over again and delete any port/interface settings that i settet up so far?
I tried to that already with another interface ip adress per subnet, but i think the routing was still going inwards on old port and did not go out again, something like that.
This thread was automatically locked due to age.
