This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

XGS 2300 Console - How to traceroute and ping by source port?

Hi Everyone,

I would like to know if traceroute and ping via source port is possible in the console? May I know the command.

Thank you,



This thread was automatically locked due to age.
Parents
  • Hello Don J,

    Good day and thank you for reaching out to Sophos Community.

    Unfortunately these options are not doable in SF

    Here is the traceroute options in console: (Can only use source IP as syntax)

    For Ping:

    On the other hand, would your use case be is to check if the destination service port is open on your end? If yes, you may try to use Telnet <IP Address> <Port Number> on a Windows machine, You may enable Telnet (if it is disabled) under Program and Features on the Windows Machine

    Cheers,

    Raphael Alganes
    Community Support Engineer | Sophos Technical Support
    Sophos Support Videos Product Documentation  |  @SophosSupport  | Sign up for SMS Alerts
    If a post solves your question use the 'Verify Answer' link.

Reply
  • Hello Don J,

    Good day and thank you for reaching out to Sophos Community.

    Unfortunately these options are not doable in SF

    Here is the traceroute options in console: (Can only use source IP as syntax)

    For Ping:

    On the other hand, would your use case be is to check if the destination service port is open on your end? If yes, you may try to use Telnet <IP Address> <Port Number> on a Windows machine, You may enable Telnet (if it is disabled) under Program and Features on the Windows Machine

    Cheers,

    Raphael Alganes
    Community Support Engineer | Sophos Technical Support
    Sophos Support Videos Product Documentation  |  @SophosSupport  | Sign up for SMS Alerts
    If a post solves your question use the 'Verify Answer' link.

Children