This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IPSec Cisco and Sophos

Hello everyone,
I want to set up an IPSec tunnel between Sophos (Head Office) and Cisco (Branch Office).

On Sophos I configured "Default Remote Gateway" as wild card (*). Because I have neither fixed IP nor ddns at the branch office.
I want to know if the tunnel goes on with wild card or not?

thank you in advance.

This thread was automatically locked due to age.

Parents

0 Vivek Jagad over 1 year ago

Hello Farzan Barouj ,

Thank you for reaching out to the community, if the Gateway type is set to "Initiate the connection." then you can not set the "*"

You can't set the Remote gateway address to a wildcard (*) for the following:
Connection type is set to Tunnel interface. You can enter one of the following: 0.0.0.0 (functions like a wildcard) IP address DNS host name Gateway type is set to Initiate the connection. You can enter one of the following: IP address DNS host name

But if you select the Gateway type is set to "Respond only" then you can select " * "

Additionally KBA for reference - Configure IPsec connection between Sophos Firewall and Cisco ASA

Thanks & Regards,
_______________________________________________________________

Vivek Jagad | Team Lead, Global Support & Services

Log a Support Case | Sophos Service Guide
Best Practices – Support Case

Sophos Community | Product Documentation | Sophos Techvids | SMS
If a post solves your question please use the 'Verify Answer' button.

Reply