Hi All,
i´m new in this Sophos world, and i have problems with the HA between two Brand new XG135.
There is no way to initiate the HA....any suggestions?
This thread was automatically locked due to age.
Hi All,
i´m new in this Sophos world, and i have problems with the HA between two Brand new XG135.
There is no way to initiate the HA....any suggestions?
Hello Stefano,
Thank you for contacting the Sophos Community!
Most likely the issue is because the appliance is set in Bridge Mode.
https://support.sophos.com/support/s/article/KB-000035744?language=en_US
* HA is supported in Bridge interface when you configure Bridge from GUI interface page. However, if you run the wizard on Bridge mode after configuring HA, HA will be disabled.
Could you please take a screenshot of your interfaces?
Regards,
Hello Stefano,
Thank you for contacting the Sophos Community!
Most likely the issue is because the appliance is set in Bridge Mode.
https://support.sophos.com/support/s/article/KB-000035744?language=en_US
* HA is supported in Bridge interface when you configure Bridge from GUI interface page. However, if you run the wizard on Bridge mode after configuring HA, HA will be disabled.
Could you please take a screenshot of your interfaces?
Regards,