This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

XG Home fails to boot

Hi all,

I have a side project where I have tried to use one of these:

To load XG Home - the unit has a Celeron CPU, 4Gb RAM and a Kingston SSD - all NIC Ports are Intel.

The issue I face is I can run the XG Home installer and it appears to work fine and I get to the music at the end where I need to remove the USB Boot device and reboot. As soon as this happens I get the Cannot Find Boot Device.

I have tried everything I can see and BIOS see's the SSD fine. The BIOS is pretty basic on this device and rfcat_vk suggested it was not waiting to find the SSD at Boot - I have no setting for this in BIOS.

Anyone have any suggestions on what I might try?

This thread was automatically locked due to age.

Parents

0 Ashen1 over 5 years ago

hi it seems i have encountered this one on my past setup of xg home (far as i remember it looked like this one)

you could try this one out and see how it goes: https://networkguy.de/?p=1845
Cancel
Vote Up 0 Vote Down

Cancel
0 M8ey over 5 years ago in reply to Ashen1

Thanks Raphael,

I am past this stage and have loaded XG Home from the USB.

My issue is then booting the device to XG OS - the installer lets me load the OS on the SSD but when I go to boot the device it cannot find any boot device.

Sophos XG 450 (SFOS 18.5.1 MR-1)

Sophos R.E.D 50 x 2

Always configuring new stuff.....
Cancel
Vote Up 0 Vote Down

Cancel
0 R S1 over 4 years ago in reply to M8ey

Hi, dit you solve the problem?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 R S1 over 4 years ago in reply to M8ey

Hi, dit you solve the problem?
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data