I feel like a total idiot with this right now. I recently tested out UTM 9 and decided I'd try this version as well. I installed it on the same hardware and I can access it all locally, but as soon as I plug my laptop in I cannot log into the web GUI at the 172.16.16.16:4444. I set the IP in my laptop to 172.16.16.1 and the net mask to 255.255.255.0. I am not able to ping or telnet to the device either. I have 2 lan ports on the device and when I change and plug into the other one I get no link lights and the laptop shows cable unplugged, but when I plug in a cable from my router the port goes active. Is there a command I can run in the console on the xg device to see the status of each interface to make sure I'm plugged into the right one? For the lan side I am plugged into the same port I used for the UTM 9, but with the other port not responding at all to my laptop connection and not being able to log into the GUI with the port I'm in, I want to make sure I'm in the right one in the first place. At this time I have done a factory reset on the device so I am starting from scratch to remove any issues I may have caused initially by doing something wrong via the menus on the local device. Any help anyone can offer would be very helpful. Thank you.
This thread was automatically locked due to age.
