Thread Info
  • State Verified Answer
  • Locked Locked
  • Replies 4 replies
  • Subscribers 5 subscribers
  • Views 4308 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Multipath Rule doesn't seem to work

Kosta88

Hello,

I have an uplink configuration, two WAN links, configured as 100/0 in the active interfaces, as I want to use the secondary link as main link only if primary dies, but I still want to be able to route certain things over secondary interface.

So I use a Multipath Rule. I want to try routing specific server over secondary interface, WAN2, so I did following:

Multipath Rule, Source: the server, Any, Any, By Interface and chosen the secondary WAN link.

Yet, when I test connections on the server, it still is going over the primary link.

How can I force the server to only use the secondary link?

Thank you



This thread was automatically locked due to age.
Unfiltered HTML