additionally to our working setup with two UTMs 120 and one RED 10, I purchased a used RED 10.
Unfortunately there is only the Power LED on and no other LED like System, Router, etc. is blinking.
So I ended up with having a look at the Sophos KB to recover the system with the AP/RED recovery tool.
But the recovery doesn't work. It seems that the RED doesn't do anything to recover itself.
There is the log:
TELNET: Start searching for RED... device found
TELNET: Connecting to RED... OK
TELNET: 63 bytes read: == Executing boot script in 3.770 seconds - enter ^C to abort
TELNET: 1 bytes sent: control sequence 3
TELNET: 13 bytes read: ^C
RedBoot>
TELNET: Successfully broke boot sequence
TELNET: 35 bytes sent: load -r -b %{FREEMEMLO} red-v2.bin
TFTP: TFTP_RRQ opcode from 192.168.99.9:7700
TFTP: Read request. Filename red-v2.bin with mode octet
TFTP: Creating file stream... Done (filestream is VALID)
TFTP: Sending filestream...
Finished changing back the network interface settings
TFTP: Closing stream... TELNET: 129 bytes read: Using default protocol (TFTP)
TFTP timed out 1/15
Raw file loaded 0x00025800-0x003cda1f, assumed entry at 0x00025800
RedBoot>
OK
TELNET: 5 bytes sent: exec
RED Flashing process started. Do not disconnect the device until either it's done, or an error occurs.
Is there any other possibility to recover it or to solve the problem?
Thank you!
This thread was automatically locked due to age.
