This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Error message when ejecting USB jumpdrives

Hi, we are runing the Management Center 6.00 and are getting some errors when ejecting jumpdrives from machines that have the encryption software installed on them. 

Error mesage that we get is:  Problem Ejecting USB Mass Storage Device  Windows can't stop your 'Generic volume' device because a program is still using it.  Close any programs that might be using the device, and then try again later.

Ideas?

:39375


This thread was automatically locked due to age.
Parents
  • Thanks.  I found that setting and I changed the policy to "Better Performance" and it will let me eject it using Windows Explorer or from Disk Management, but I still get the error when try to eject the drive from the little icon down by the clock.  Could it be the brand of jump drive that I am using?  I have tried a few different brands but haven't come up with anything yet.

    :39427
Reply
  • Thanks.  I found that setting and I changed the policy to "Better Performance" and it will let me eject it using Windows Explorer or from Disk Management, but I still get the error when try to eject the drive from the little icon down by the clock.  Could it be the brand of jump drive that I am using?  I have tried a few different brands but haven't come up with anything yet.

    :39427
Children
No Data