This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Migrating from UTM 220 to SG 230

I've recently started a new position at a firm utilizing a Sophos UTM 220 appliance. This is my first time managing Sophos equipment.

They have purchased a brand new SG 230 appliance to replace the older unit. Am I correct that I should be able to take an unencrypted backup from the UTM 220 and restore it to the SG 230 via USB to transfer the previous configuration? The SG 230 will be completely replacing the UTM 220. I do know I should have the new license file ready to apply to the 230.

Current UTM version is v9.305-4. I've done some searching around but have not had much success finding much on migrating devices. Any gotchas I should be aware of? Any advice is appreciated. Thank you!


This thread was automatically locked due to age.
  • I've only tried that experiment once, Stephan - it failed for me, too, so I assume you should do as trollvottel prescribed above and completely wire it up.  Out of an abundance of caution, I would Factory Reset the new 230 before connecting it again.

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA