This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Noob on utm

Hello.

I am new on Sophos utm and I need a bit of help from you guys.

I managed to make it run with a few rules.

I have a lan for my pc, server and a few small nas, IP …,...,23,...

I have another lan for my wifi IP …,...,0,... for some gadgets (xiaomi vaccum,xiaomi sensors,xiaomi gateway,HUE,mobile phones,smart tv )

My mobile talk with the hue bridge but with xiaomi don't.

My Sophos is on a pc and I use an separate ethernet port to give ip to hp 8 port switch(4 for locals and 4 for wifi) with 2 vlans for the 2 ip ranges.

The wifi is spread by a tp link AP.

Hope my message is not to messed up and you guys can help me a bit.

Thx in advance

Raz

This thread was automatically locked due to age.

0 PatrickLee over 4 years ago in reply to Turloiu Razvan

Post your FW live log and narrow to the IP address of your gateway similar to example below
Cancel
Vote Up 0 Vote Down

Cancel
0 Turloiu Razvan over 4 years ago in reply to PatrickLee

Right now is not even showing any FW activities on the gateway ip.

Only the ip of the phone that is trying to add the gateway to the mihome app.

:(
Cancel
Vote Up 0 Vote Down

Cancel
0 PatrickLee over 4 years ago in reply to Turloiu Razvan

Temporary create a top FW rule allowing your mobile phone and Mi Gateway IPs for outbound traffic as in example below

phone / gateway ----> any ----> any

reset your gateway and connect to your phone

once your gateway is added to your phone via Mi Home app, then apply the previous mentioned FW rule.
Cancel
Vote Up 0 Vote Down

Cancel