[8.200][QUESTION][ANSWERED] When are we likely to see RC2 witha fix fo rthe http performance

Hi folks,
no mention anywhere of the issue is being addressed other than one of Scott's answers.

I had been blaming the overseas connections from my ISP, because most of the time the local connections have worked quite quickly, but not as quickly as in previous 8.2beta versions.

Ian

0 Astaro Beta Bot over 12 years ago

Astaro Beta Report

--------------------------------

Version: 8.200

Type: QUESTION

State: ANSWERED

Reporter: RFCat_vk

Contributor: Scott_Klassen

MantisID: 

Target version: 

Fixed in version: 

--------------------------------

0 Scott_Klassen over 12 years ago

Well, we're already past RC's. Soft-releases are a sort of in-between state. If no problems are found, then soft-release becomes final code. If problems are found, then there may be several different soft-release builds.

In response to your specific question, I may have heard that http performance is targeted for the 8.201 u2d, which should be released VERY quickly after 8.200 goes GA (anywhere from same day to a week later would be my guess).

I feel your pain here. I find myself needing to reboot my 8.200 Astaro twice a day.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 RFCat_vk_01 over 12 years ago in reply to Scott_Klassen

Maybe we need to go back a step to an RC.

I haven't had to restart my ASG yet because it has lots of memory, but I have an observation that the issue seems to be load based eg lightly loaded very poor performance heavily loaded good performance.

I was using the internet and the network load was in the low kbs of traffic, this site took forever to load and so did a lot of other sites. At the moment the ASG network traffic is running around 3.5mb/s and all sites are loading very quickly.

Ian
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Scott_Klassen over 12 years ago

Soft-release is kind of an additional RC, just by a different name that sounds better to the marketing folks. [:)]

My proxy performance issue may be different than yours. Nothing that says there can't be multiple bugs. Mine starts with a segfault, which I believe leads to a memory leak. 2GB ram, memory usage stays around 70%, but my system starts using Swap. Swap usage slowly creeps higher and higher and performance gets lower and lower until I reboot.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 RFCat_vk_01 over 12 years ago in reply to Scott_Klassen

My ASG http proxy is configured in many different ways.
1/. the general VLAN with bridged wireless is using full transparent mode
2/. the fallback is using standard mode
3/. the wireless for guests is using Standard mode with https scanning enabled

With heaps of memory usage creep.

No segfaults.

Ian
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 utm_kid over 12 years ago in reply to Scott_Klassen

My proxy performance issue may be different than yours.  Nothing that says there can't be multiple bugs.  Mine starts with a segfault, which I believe leads to a memory leak.  2GB ram, memory usage stays around 70%, but my system starts using Swap.  Swap usage slowly creeps higher and higher and performance gets lower and lower until I reboot.

Yes i also notice this and reported here  http://www.astaro.org/astaro-beta-versions/asg-v8-200-beta/asg-v8-200-beta-closed-threads/36246-8-160-info-none-ram-usage-discussion-2.html#post169296  (part of full thread ) but if u add 1 mb ram more ram usage goes to max 50-55 % and no swap file in use at all but when u r with 2 gb ram ram usages goes to 70-80 % and start using swap file which i dont understnat
half of 3 gb ram is 1.5 mb ram  ,so systm use 1.5-1.8 mb ram
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel