SFOS v18 Early Access Program (Read Only)

Feedback and Issues CPU peaks when performing nessus scan (specific on port 5060)

SFOS v18 Early Access Program (Read Only) requires membership for participation - click to join

CPU peaks when performing nessus scan (specific on port 5060)

JercoVeltjen TEST over 4 years ago

Hi

I am doing vulnerability scans and the CPU peaks to 90 - 95 % when doing a port scan.

Saw this specific to port 5060 but others also.

Best Regards,

Jerco

0 rfcat_vk over 4 years ago

What are you using port 5060 for?

Ian

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 EAP

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Big_Buck over 4 years ago

Port 5060 is often related to an IP Phone ... SIP Protocol. Same for 5061.

Paul Jr
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 rfcat_vk over 4 years ago in reply to Big_Buck

Hi Paul,

yes, I realise that use and suspect that the XG has active connections which the scan is causing confusion with.

Ian

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 EAP

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 JercoVeltjen TEST over 4 years ago

Hi guys,

I am using a nessus scan to scan the hosts and all ports of my network for vulnerabilities.

With version 17.5 there was no issue and now with the EAP the CPU spikes always when the scan is running.

ps I am not running anything on port 5060 :)

Best regards,

Jerco
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel