simple port forwarding

Hello

V18 rules is confusing for now, how do i create a simple port forwarding, to allow access to a port from outside?

Thanks

Parents
  • It is very confusing:

    1. Create a NAT, under Rules and policies. For example,
    2. Create a Firewall rule to allow traffic from Any to WAN zone where destination network/host is the WAN ip address

  • Hello Luk,

    please check ( below ) the DNAT firewall rule and appropriate DNAT rule. Especially focus on the Destination Zone and the Destination Network in the firewall rule. The Destination Zone is LAN zone and #PortB: 1 is the alias address on the WAN interface! It is very interesting interconnection of the Destination Zone and the Destination Network!

    This is not me, but it is the result of business rule migration from v17.5 to v18 EAP1. But it really works. I learned something new again thanks to Sophos ...

    However, it is important that the DNAT rule must be before the masquerading rule (MASQ) otherwise of course "matches" the User Portal. 

    Regards

    alda

    [:(]

     

     

     

     

Reply
  • Hello Luk,

    please check ( below ) the DNAT firewall rule and appropriate DNAT rule. Especially focus on the Destination Zone and the Destination Network in the firewall rule. The Destination Zone is LAN zone and #PortB: 1 is the alias address on the WAN interface! It is very interesting interconnection of the Destination Zone and the Destination Network!

    This is not me, but it is the result of business rule migration from v17.5 to v18 EAP1. But it really works. I learned something new again thanks to Sophos ...

    However, it is important that the DNAT rule must be before the masquerading rule (MASQ) otherwise of course "matches" the User Portal. 

    Regards

    alda

    [:(]

     

     

     

     

Children