Important note about SSL VPN compatibility for 20.0 MR1 with EoL SFOS versions and UTM9 OS. Learn more in the release notes.

Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 4 replies
  • Answers 1 answer
  • Subscribers 39 subscribers
  • Views 20697 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IPSec site2site tunnel routing issues

crusherv9

Hi,

I already setup several IPSec tunnels on Sophos XG, but this time it doesn't work. The two green lights show up, tunnel seems to be up, because the remote site (Fortigate FW) can ping our domain controller. A ping to the server on the remote site fails.

"system ipsec_route show" showed no routes so I set up one:


tunnelname host/network netmask
plusserver 172.16.0.0 255.255.255.0

doing a traceroute stops at the first provider router. I also configured SNAT:

set advanced-firewall sys-traffic-nat add destination 172.16.0.0 netmask 255.255.255.0 snatip 192.168.0.254

 

Local Site:

Network: 192.168.0.254/16

 

Remote Site: 
Network: 172.16.0.0/24

Thank you in advance!

 



This thread was automatically locked due to age.
Parents
  • 0

    Ludwig,

    try ti recreate the Site to Site vpn. Make sure LAN to VPN and VPN to LAN firewall rules exist.

    I had an issue with VPN where one network was not working and the problem was a "ghost route" inside the XG table. Use route -n from advanced shell and check the routing table before re-creating the tunnel again.

    Regards

Reply
  • 0

    Ludwig,

    try ti recreate the Site to Site vpn. Make sure LAN to VPN and VPN to LAN firewall rules exist.

    I had an issue with VPN where one network was not working and the problem was a "ghost route" inside the XG table. Use route -n from advanced shell and check the routing table before re-creating the tunnel again.

    Regards

Children
Unfiltered HTML