Hi,
I am trying to install XG Home Edition on Hyper-V. I followed the Virtual Appliance documentation as far as I could because it only covers VMWare. I created a VM using the minimum requirements and installed XG Home no problem. When it is up and running I see a command prompt with a menu system to use for configuration. The document says you should connect to 172.16.16.16:4444 to use the GUI but the computer hosting the VMs is running 192.168.10.xxx. I'm assuming that the IP my VM host has is incompatible with the firewall and cannot display the firewall GUI.
What do I need to do next so I can configure everything required? Is it possible to change the firewall so it uses 192.168.10.xxx so I can access the firewall GUI? Should I just do everything from the command line? What is best practice in setting up this firewall correctly?
Thanks,
Rob
This thread was automatically locked due to age.