Important note about SSL VPN compatibility for 20.0 MR1 with EoL SFOS versions and UTM9 OS. Learn more in the release notes.

Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 7 replies
  • Answers 1 answer
  • Subscribers 41 subscribers
  • Views 4567 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Lost access/ internet after creating a bridge

jang430

I'm using port 1 as LAN, port 2 as WAN, and port 3 as backup WAN.  So far, so good.  I decided to try creating a bridge, since, why not?  I have excess ports.  I chose ports 5 and 6, assigned both to LAN, and gave it an IP address of 192.168.1.x.  My firewall has IP of 192.168.1.1 btw.  All of a sudden, I lost internet, wired/ wireless.  My wired PC connected to the network can no longer access 192.168.1.1.  How do I fix this?

I don't have a console cable.  Any other way to reach it again via other ports?



This thread was automatically locked due to age.
Parents
  • 0

    Hi,

    what sort of hardware are you using? Is port 4 configured for access? Do you have a backup of the configuration before you changed the interfaces configuration?

    Ian

    XG115W - v20.0.2 MR-2 - Home

    XG on VM 8 - v21 EAP

    If a post solves your question please use the 'Verify Answer' button.

  • 0 in reply to rfcat_vk

    I am using old Sophos firewall XG 135 appliance. I don't have the latest backup, but I have something that is good enough for it to work. So does that mean load backup? 

    I don't understand what configured for access means, therefore, most likely not :-) Port 4 originally unbound, so as the rest, except for 1, 2 & 3. 

  • 0 in reply to jang430

    Hi.

    if you can't access the device you can't load the backup. I was asking if port 4 was configured for any form of access.

    You can perform a hardware reset and then load the backup.

    Ian

    XG115W - v20.0.2 MR-2 - Home

    XG on VM 8 - v21 EAP

    If a post solves your question please use the 'Verify Answer' button.

  • 0 in reply to rfcat_vk

    Saw that I can by plugging usb in and have backup renamed as restore.abf? Or can't I?

  • 0 in reply to jang430

    Hi  jang430 

    Try to access the firewall with WAN IP and enable appliance access from console this might help to revert back the changes 

    enable it with the following command.

    system appliance_access show

    system appliance_access enable

    system appliance_access disable

    Regards

    "Sophos Partner: Networkkings Pvt Ltd".

    If a post solves your question please use the 'Verify Answer' button.

  • 0 in reply to Bharat J

    Thank you. I will keep that in mind in case I attempt again :-) already initiated reset to factory default.

Reply Children
  • 0 in reply to jang430

    Hi  jang430 

    if you want a redundant connection between your switches, try to set up a LAG instead of a bridge.

    Use a different, unused network range on the interfaces instead of using the same one.

    "Sophos Partner: Networkkings Pvt Ltd".

    If a post solves your question please use the 'Verify Answer' button.

Unfiltered HTML