Important note about SSL VPN compatibility for 20.0 MR1 with EoL SFOS versions and UTM9 OS. Learn more in the release notes.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Sophos Firewall: v20.0 GA: Feedback and experiences

Release Post:  Sophos Firewall v20 is Now Available  

The EAP Post:  Sophos Firewall: v20.0 EAP1: Feedback and experiences  

The old V19.5 MR3 Post:  Sophos Firewall: v19.5 MR3: Feedback and experiences  

To make the tracking of issues / feedback easier: Please post a potential Sophos Support Case ID within your initial post, so we can track your feedback/issue. 

Release Notes:  https://docs.sophos.com/releasenotes/output/en-us/nsg/sf_200_rn.html 



This thread was automatically locked due to age.
Parents
  • Is it possible that there is an issue with editing an existing S2S VPN connection?
    I have rolled out several XGS136 with V20 at a bigger customer project now and experienced the same issue with 3 firewalls.

    I have an existing S2S tunnel (checkbox "Activate on save" is checked).
    I have a several local networks to any remote network tunnel setup with policy based vpn (since I need DHCP relay).

    When I add a new subnet on the local side and save the connection the state of it goes red/red instead of green/red or green/green.
    I then have to connect via WAN to the firewall, click the "Activate" icon and it goes up green/green like expected.

    Regards,

    Kevin

    Sophos CE/CA (XG, UTM, Central Endpoint)
    Gold Partner

Reply
  • Is it possible that there is an issue with editing an existing S2S VPN connection?
    I have rolled out several XGS136 with V20 at a bigger customer project now and experienced the same issue with 3 firewalls.

    I have an existing S2S tunnel (checkbox "Activate on save" is checked).
    I have a several local networks to any remote network tunnel setup with policy based vpn (since I need DHCP relay).

    When I add a new subnet on the local side and save the connection the state of it goes red/red instead of green/red or green/green.
    I then have to connect via WAN to the firewall, click the "Activate" icon and it goes up green/green like expected.

    Regards,

    Kevin

    Sophos CE/CA (XG, UTM, Central Endpoint)
    Gold Partner

Children