Just to confirm
HA requirements - Sophos Firewall
-
DHCP and PPPoE: When the interfaces are dynamically configured using DHCP or PPPoE, the following applies:
- Active-active mode: Not supported.
- Active-passive mode: Supported, but session failover isn't supported.
Active-Active is not suported if my WAN interface is configured with PPPoE?
The cables going out from the firewall to the WAN or LAN switch must be configured with LAG? can I just plug them to the switch with no specific config? for example it would work with an unmanaged switch?
This thread was automatically locked due to age.