This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Setup A Static IP on XG310 for Management

Our production firewall is an XG310, but we also have an SG310 as a backup.

On the backup, I have setup routing and firewall rules in case something happens with the production firewall. In an emergency I can unplug the LAN and WAN cables from the prod XG and plug into the backup SG.

I would like to have a static IP assigned to another port on the backup SG that I can use for configuration and firmware patches. How do I go about setting this up?

Thank you.

This thread was automatically locked due to age.

Parents

0 lferrara over 4 years ago

tripleview,

you can configure an unused port on XG, configure an IP address and put into LAN or create a new zone. If you create a new ZONE, make sure to enable HTTPS management checkbox for the new zone under Administration > Device Access.

Regards
Cancel
Vote Up 0 Vote Down

Cancel
0 tripleview over 4 years ago in reply to lferrara

I will check the device access... what I have done so far is put Port5 on the SG310 on the Management network with a static IP and mask of /32 - should that work?
Cancel
Vote Up 0 Vote Down

Cancel
0 lferrara over 4 years ago in reply to tripleview

Tripleview,

This will work if you are connected on a different lan segment. Take note that /32 will not allow you to put a computer in the same subnet and connect to the device directly on the management ip.

Regards
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 lferrara over 4 years ago in reply to tripleview

Tripleview,

This will work if you are connected on a different lan segment. Take note that /32 will not allow you to put a computer in the same subnet and connect to the device directly on the management ip.

Regards
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data