Hello,
I have UTM installed on one i3 PC, running home edition.
So I wanted to try out XG, since we do plan to do it eventually at work too (SG125 there).
So I went ahead and installed XG one a 2nd drive, what went well (well is a loose term, it took me 3 hours to install it, but never mind that)...
When I wanted to switch back, all was well except my AP15 access points. They seem to have some problems.
After I installed XG, they were showing as inactive. I configured wireless and the AP, rebooted them, and all was fine.
But then I reverted to UTM, and they were showing yellow exclamation mark. I waited a while, nothing happened.
Rebooted the AP - nothing.
Removed, readded - at first still nothing, but then after a while, like 10min or so, they started working again.
As I want to repeat this procedure, it would be good to know what's happening in the background and if I can somehow speed up the process?
Thanks
This thread was automatically locked due to age.