Important note about SSL VPN compatibility for 20.0 MR1 with EoL SFOS versions and UTM9 OS. Learn more in the release notes.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Sophos XG Virtual Appliance - SNMP Issues - Cannot get Graphics with Zabbix

Hello everyone,

I need your help with some issues about Sophos Virtual Appliance - SNMP Monitoring, I've been trying to obtain bandwidth information but it not works, from a zabbix server i've been doing some SNMP query with snmpwalk to the destination IP but the firewall shows me an incomplete MIB.

This is the output of snmpwalk command from zabbix server:

 

When i trying against the Physical firewall it show me the next output with more information and it can monitored with zabbix with the same templates and configurations.

 

When i look the configurations of zabbix is all correct. Firewall rules are OK because is the same rule applied to a other monitoring servers, Device access from the source zone is marked with SNMP.

 

Best Regards!

 

 

 



This thread was automatically locked due to age.
  • FormerMember
    0 FormerMember

    Hi Siedhart,

    Can you run tcpdump on port 161 or 162 on firewall when you try to SNMP query? and provide the output? If possible please provide the screenshot of SNMP configuration from virtual XG firewall.

  • Hi H_Patel,

    here is the output of TCPDUMP on the firewall:

     

     

    and here is the firewall config:

     

    1.- Device Access on the DC Zone where inbound and outbound traffics for the zabbix server:

     

     

    2.- SNMP Configuration:

     

    Here is the configuration of the SNMP COMMUNITY and the IP Server zabbix 10.41.0.109.

     

    Regards!

  • FormerMember
    0 FormerMember in reply to Enz0h

    Hi Siedhart,

    I apologies for delay in response. TCPDump shows traffic blow from both direction, have you noticed any SNMP traffic being dropped on the firewall? 

    Thanks,